BIOS-Setup (486 DX4-100 Motherboard/AMI-BIOS)
1) Switch off the Photo Play 2000. Open the cabinet and connect an standard PC-keyboard (102
keys).
2) Switch on the Photo Play 2000 and press the > DEL < or > ENTF < key until you get into the
BIOS SETUP menu.
3) Select "Standard" from the menu using the > cursor < and > enter < key.
4) Select Date/Time and enter the correct date/time with > + < or > - <. Leave this menu with >
ESC <. You will be again in the "Standard Setup".
5) Floppy A --> "not installed"
Floppy B --> "not installed"
6) Select "Master Disk" and select the Type > USER < (with cursor and enter key):
Enter this values:
TYP CYL HD WP LZ SEC SIZE
USER 1024 16 0 0 63 504
6.1) Slave Disk --> "not installed" (not available at most boards)
7) Press > ESC < until your in the "Setup Menu".
Select "ADVANCED Setup".
Make the following changes (with cursor and enter key):
System Keyboard absent
Wait for F1 if any Error disabled
System Boot up sequence C: A:
Primary Master LBA Mode disabled
9) Select "CHIPSET Setup".
Make the following changes (with cursor and enter key):
Auto Configuration: disabled
Cache Speed 3-2-3
DRAM Read Wait State 3 W.S.
DRAM Write Wait State 3 W.S.
PCICLK - to - ISA SYSCLK Divsor: PCICLK/4
Keyboard Clock Divsor: PCICLK/4
10) Press > ESC < until you see the window "Exit Setup". Select "Save changes and exit" and press
> ENTER <.
