De retour sur mon souci,
J'ai de nouveau testé le contact EOS de flips gauche au niveau du connecteur 906 de la Fliptronic et j'ai remarqué qu'une fois sur deux, le contact ne semblait pas se faire.
J'ai donc suivi le fil concerné et j'ai trouvé une coupure dans le fronton, une vingtaine de centimètres après le connecteur.
Il est désormais détecté en test.
Pour ce qui est de la chauffe des bobines, je pense que cela vient des optos au niveau des boutons de flip
Selon MARVIN "
On WPC fliptronics and later games, try cleaning the "U" shaped optics on the cabinet flipper opto boards. Use a Q-tip and some Windex to clean them. Also make sure the opto activator bars fully clear the optos when the cabinet switch is pressed. If one weak flipper still exists, try swapping the cabinet flipper opto boards (remember, both flipper boards must be plugged in for this to work!). If the weak flipper problem moves to the other flipper, the opto board's optic has become faulty, and it will need to be replaced with a new "U" shaped optic. A marginal cabinet flipper board optic, even if clean, can cause a weak flipper. Replace if in doubt. Also check the opto switch with your multimeter. With the game on and your meter set to DC volts, on the flipper opto board measure the connector pin marked SW1 and SW2 against ground. A measure of below 0.7 volts (below 1V is OK) should be shown, with the button pressed. A higher reading means a dirty or defective opto switch. If cleaning does not remedy the problem, replace the opto switch. NOTE Later WPC-95 pinballs use a Schmitt Trigger opto switch (3 legs on the receiver, 2 on the transmitter) which eliminates this problem. The Schmitt trigger optos will not oscillate (turn on and off quickly, making the flipper weak) when the optics gets dirty. They usually either work, or don't work."
J'ai donc testé SW1 et SW2. Je trouvais des deux côtés 3,6volts lorsque chaque flip était appuyé.
Après nettoyage des optos, je trouve maintenant 1,6V - C'est mieux mais je ne parviens pas à descendre en dessous du 1V préconisé.
Après plus d'une heure de jeu, en maintenant les batteurs assez souvent en position levée, pas de perte de puissance.
Je pense donc que le pb viendrait de là
Je ne manquerai pas de venir confirmer sur le post une fois les cartes opto remplacées, que le problème est résolu!
C'est quand même mieux et simplement utile un post "clôturé"
Merci à Faboule et Jb
